Direct printing-on glove cut pieces or finished products-is widely used for patterns and logos, but poor screen silicone adhesion is a major pain for manufacturers, causing high scrap rates and reputational damage. This issue stems from multiple linked factors, not a single cause. Below is a concise analysis of core reasons to help address it effectively.
1. Mesh Selection and Treatment
Mesh is foundational for adhesion. A 180-250 mesh polyester screen is ideal; too high (over 300 meshes) limits silicone transfer, while too low (under 150 meshes) causes over-thick, poorly bonded layers. Uneven tension (should be 25-30N/cm) or dirty mesh also reduces adhesion by blocking silicone-substrate contact.
2. Glove Substrate Issues
Substrate compatibility and pretreatment are key. Low-surface-energy materials (nitrile, latex) need plasma activation or primer to improve bonding. Fabrics with sizing agents or moisture form barriers, while insufficient cleaning/drying creates bubbles during curing, leading to peeling.
3. Screen Silicone Quality
Qualified silicone must have proper viscosity and curing agent ratio. Incorrect ratios cause incomplete/over-curing, while lacking adhesion promoters (e.g., silane coupling agent) prevents firm chemical bonding with substrates.
4. Scraper, Machine and Operation
Scraper hardness (70-80 Shore A) and angle (45°-60°) must be correct; worn scrapers or uneven manual pressure cause uneven silicone transfer. Machine workbench flatness and mesh distance (1-5mm) also affect adhesion, as do unstandardized manual operations (e.g., contamination).
5. Curing Process
Curing temperature (80-120℃ for low-temp, 200-220℃ for high-temp) and time (30-60min/10-30min) are critical. Improper settings or high humidity (over 70%) lead to insufficient cross-linking and bubbles.
In summary, solving poor adhesion requires matching mesh, silicone and substrate, standardizing pretreatment, operation and curing. As a professional screen silicone manufacturer, we offer tailored materials and guidance to resolve this issue efficiently.
Direct printing-on glove cut pieces or finished products-is widely used for patterns and logos, but poor screen silicone adhesion is a major pain for manufacturers, causing high scrap rates and reputational damage. This issue stems from multiple linked factors, not a single cause. Below is a concise analysis of core reasons to help address it effectively.
